all 19 comments


2

none OG Vendor

Get some peanut butter, the non crunchy kind. Needs to be real peanut butter, the kind where the ingredients only says "Peanuts".

What you do is you put peanut butter on the top and back of the ID about 1/2 inch thick. So put it on a plate then put the ID on top of it, then put 1/2 inch thick of peanut butter on top of it.

Put it in the microwave for about 25 seconds, this will not affect the ID since it's in peanut butter.

Once you're done let it sit for about 1 minute so the peanut butter can cool down then use a butter knife to scrap the excess peanut butter off, then use a paper towel to rub it and BAM you got a perfect semi gloss looking ID.

It's called the "Peanut butter Method" I forget who discovered it but it seems to work.


1

FoundingFathers Vendor

I believe Unkn0wn was the pioneer of the peanut butter method after extensive research following the aluminum foil line of thought didn't pan out.


1

realSalzinator - Last Surviving OG

Smother it in peanut butter, microwave for 45 seconds. The Peanut butter acts as an insulator and will also give it the worn look. rinse after


1

none OG Vendor

I beat you to it


1

realSalzinator - Last Surviving OG

By like 1 second >:(((


1

deadmigit

a lot of people use peanut butter but i rub mine on a mousepad and it does some surface scratches and makes it look worn


1

DesertFoxCS CS

Peanut butter


1

brienr¡ver

peanut butter